Accessories   Center Entry Adaptor Part #: 1100-400 This adaptor is used for terminating 180º center entry connectors. When attached to the UT this adaptor will correctly position the cable clamp above the connector creating a consistent distance from the cable jacket end. The multiple adjustments on this adaptor allow it to be used with all connector manufacturers.   Discrete Wire Cable Clamp Part #: 1100-480 (Standard Version)            1100-450 (18” Mounting Plate Version) This clamp replaces the standard cable clamp and is used when requiring additional force to clamp loose discrete wire for termination. Whether you are clamping just a few wires or you are clamping a full cable of wires this cable clamp has an easy to use single adjustment for cable grip. We offer this cable clamp in two styles, the standard is a direct replacement for our standard cable clamp and the 18” version utilizes a 18” plate used with pre-tapped holes for mounting fixtures and a built in ruler for properly aligning the cable jacket length.   Cable Clamp Squeezer Part #: 1100-770 The squeezer is designed for Amphenol/Cinch connectors to hold the cable down then close the connector cable clamps. This device eliminates the need for the operator to manually close the cable clamps after the connector/wire assembly is complete. Used on Amphenol & Cinch cable clamp connectors   Block Assembly Part #: 1100-830 Used for terminating connectors onto the telephone industry block assemblies. This fixture is adjustable to allow between a 2.5” – 5.5” length between the terminated connector and the block assembly.   Insertion Blade Alignment Kit Part #: 1100-980 This alignment kit accurately adjusts the insertion blades front to back. Correct positioning of the insertion blades prevent scraping plastic or damaging the contacts in the connector.   Wire Guide Adjustment Kit Part #: 1100-981 This kit helps to properly set the wire guide depths for Amp, Amphenol, & Cinch .085” Miniature Ribbon connectors.   Program Plates Part #: 1100-2XX Program plates are needed when running the Universal Terminator without the electronic programmer. Each program plate is made for one size connector. Please specify what size and style connector when ordering.